![]() I've heard this does the trick and you can idle forever. 2) Hit the brake and the accelerator at the same time just after you start idling. NOTE: If a 84-08 Vehicle Speed Signal Out Of Range (36) Diagnostic Code is Active, the Idle Shutdown Timer will not operate. 878 949 North Carolina 0 1) Hit the brake, clutch, or accelerator when your dashboard warning light goes on just before shutdown. The Idle Shutdown Feature can be temporarily disabled using an Electronic Service Tool through the System Troubleshooting Settings screen to help troubleshoot other problems and avoid nuisance engine shutdowns when troubleshooting other systems. The ECM will shut down the engine but not the vehicle electrical system when the Idle Shutdown Time expires. Code 71-01 records the event and does not indicate an electrical/electronic system malfunction.ĭisable the Timer by programming Idle Shutdown Time to zero (Caterpillar Factory Default). If the timer is activated and allowed to shut down the engine, then an Event Code 71-01 Idle Shutdown Timed Out (47) will be set. ![]() YES is the Caterpillar Factory programmed default for the Allow Idle Shutdown Override parameter (allowing override is the default). Joe briefly explains how to disable this feature. If the parameter Allow Idle Shutdown Override is programmed to NO, the Timer can not be overridden using the brake or clutch during the final 90 second idle shutdown period. Your vehicle is equipped with an idle engine shutoff, meaning after about 30 minutes, the engine shuts off. An event Code 71-00 Override of Idle Shutdown Timer (01) will be logged when the driver overrides the timer using the clutch or brake during the 90 second period. During the 90 second perriod, if the drive moves the clutch pedal or service brake pedal, a timer override may occur until the timer is reset. Ninety seconds before the programmed time is complete, the Check Engine/Service Engine Soon lamp will begin to flash rapidly. The timer is activated when the vehicle speed is zero, the engine is not in Cold Mode or dedicated to PTO Mode, and the engine is not under load, regardless of the parking brake position. The Customer Parameter Idle Shutdown may be programmed for any period from 3 to 60 minutes. The Idle Shutdown Timer is intended to improve fuel economy by limiting idling time. Use this procedure to determine if the Idle Shutdown feature is operating correctly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |